![]() The degree of change/improvement from crossfeed is also very dependent on the recording/mastering.Code Apr 04 17:40:04 LibreELEC systemd: Started librespot.Īpr 04 17:40:04 LibreELEC sh: INFO:librespot: librespot 0a89bee (). I expect that for people who use no DSP at all, adding crossfeed is a bigger step than adding it to an already "impure" chain. So the initial break from sending the pure source signal has already been made. For various reasons, I'm already in the situation where everything is from a digital source, and some DSP is involved. Personally, I thought that crossfeed was a load of nonsense for a long time, but eventually realized that there are just a lot of really poor implementations out there. ![]() I also tried the Phonitor amps but was not happy as everything in the lower registers almost disappeared and became "limp": very compressed and not dynamic or impactful at all. I tried Isone, but only briefly, and to me it seemed to be a bit "muddy", losing/masking some low-level detail, compared to CanOpener. ![]() Some of us prefer GoodHertz CanOpener, which doesn't attempt a room simulation. Part of the IVS is Waves NX, which is a virtual room simulation, so even more than crossfeed. There is a lot of good info in discussions about and around Immersion Virtualization System, see e.g. This is a point where opinions vary a lot (ha, like what isn't?). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |